59
Release Notes for 07.8.04 Known Issues in 07.8.03
Known Issues in 07.8.03
This section lists the known issues in software release 07.8.03.
ProCurve 9300M Series Modules
Table 9 lists the modules that are currently available for use in ProCurve 9300M Series routing switches.
(Discontinued modules are also listed.)
82608 Module: N/A
Symptom: In a Switch or Router, the link activity
LED on the port with ER-Xenpak optics is off on
either end, while the traffic is passing uninterrupted.
Resolution: Fixed in this release.
System 07.8.04a
85354 Module: N/A
Symptom: In a Switch or Router, sometimes a
corrupt or inconsistent port data structure can cause
a system reset.
Resolution: Fixed in this release.
System 07.8.04a
Table 8: Known Software Issues in Release 07.8.03
Bug ID Bug Description Protocol
Feature
59070 When PBR is configured with a route map that has multiple instances, each
with a different match criteria and respective next-hop, the CAM entries are
programmed for matched traffic with the next hop of the first instance. If the
other instances of the route map match, the CAM is still programmed with
the next hop of the first instance of route-map.
PBR
60396 A static MAC address for only one port is displayed in show interface
command output if the address is configured for multiple ports.
Static MAC
61392 When CPU protection is enabled, a hardware flooding CAM entry does not
match the unknown traffic. As a result, these packets are not forwarded or
are discarded in hardware.
CPU
Protection
61914 Strict security is not supported by 802.1X. 802.1X
62370 When CPU protection is enabled, CPU utilization is always around 50%
when sending unknown unicast traffic.
CPU
Protection
62562 Changes in an outbound rate-limiting configuration may require 300
seconds to take effect.
EP Rate
Limiting
Bug ID Bug Description Protocol/
Feature
Version
Found
Version
Fixed
