A SERVICE OF

logo

30
Setup
Setting the Color Density
The printer panel provides an interface to adjust the density of the toner applied to the
media. This makes it possible to offset changes in density that may result due to varying
environmental conditions or aging of the toner or imaging unit.
Perform the following steps to adjust the color density:
Begin by printing a Color Calibration Page. To print a Color
Calibration Page, proceed as follows:
1
(1) Press the MODE key on the printer panel.
(2) Press the + key repeatedly until the message display indicates
Color Calibration.
Color >
Calibration
(3) Press the key.
(4) Press the + key until the message display shows >Print
Calibration Page.
>Print Calibra-
tion Page
(5) Press the ENTER key. A question mark (?) will appear.
(6) Press the ENTER key again.
A Color Calibration Page will be printed.
(2), (4)
(3)
(5), (6)
(1)