142
Other Settings for the Remote Controller
—Continued
This section explains how to change the remote control-
ler’s ID. You may need to change this if the DTR-10.5’s
remote controller interferes with other Integra/Onkyo
components located in the same room.
Note:
If you change the remote controller’s ID, be sure to
select the same ID on the DTR-10.5. For details on set-
ting up the DTR-10.5’s remote control ID, refer to the
“Remote Control Setup Sub-menu” section on page 87.
The default ID for both the DTR-10.5 and remote con-
troller is 1.
Changing the Remote Controller’s
Control ID
1
Hold down the remote controller’s [Cus-
tom] button for more than three seconds.
The remote controller enters Custom mode.
2
Roll the scroll wheel to select “SETUP”
menu, and then press the scroll wheel.
3
Roll the scroll wheel to select ID menu,
and then press the scroll wheel.
4
Roll the scroll wheel to select an
ID—1 (default), 2, or 3—and then
press the scroll wheel.
Select the same ID as that set on the
DTR-10.5.
