Page 46
English
6 Repeat step 5 until you program up to 16 steps.
Notes:
• If the ERROR indicator flashes several times, you cannot program this step.
– 16 steps are already programed or this particular step is not programmable.
• You cannot program an operation performed by pressing two buttons at the same time — like pressing
¶ and 3 at the same time to start recording.
• Do not program a TV operation step immediately after the step of turning on the TV. The TV operation
may be ignored since the TV is not yet ready to accept the signal.
7 Press LEARN again to finish the programing procedure.
Both the SEND/LEARN and ERROR indicators go off.
CAUTION:
When replacing the batteries, finish it without delay; otherwise, the stored signals are all erased.
Erasing a program
1 Open the outside panel of the remote control.
2 Press LEARN so that the SEND/LEARN indicator lights up (green).
3 Press CANCEL.
Both the SEND/LEARN and ERROR indicators light up.
4 Close the outside panel, and press and hold SEQUENTIAL PROGRAM KEY A, B, or C to
which the program you want to erase has been assigned to, until both the SEND/LEARN and
ERROR indicators start flashing.
Note:
If the ERROR indicator remains lit, no program is assigned to the SEQUENTIAL PROGRAM KEY.
In this case, press CANCEL to turn off the ERROR indicator.
5 Press LEARN again to finish the erasing procedure.
The SEND/LEARN indicator goes off.
SEND/LEARN ERROR
SEND/LEARN ERROR
Lights
Remote: Inside
Remote: Inside
Remote: Outside
SEQUENTIAL PROGRAM KEY
ABC
SEND/LEARN ERROR
Lights
Lights
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
SEND/LEARN ERROR
Flashes
Lights
Flashes
SEND/LEARN ERROR
Remote: Inside
CANCELLEARN
CANCELLEARN
CANCELLEARN
CANCELLEARN
Remote: Inside
RX-730RBK(EF)0054-001A.En.42-52 97.7.25, 7:06 PM46
