A SERVICE OF

logo

Open as PDF
next previous
8282 83
Return to the Top page
Audio Setting Up
Return to the Top page
Audio Setting Up
NOTE
•Eachoperationinthissectioncanbestartedfrom
themultifunctionmenu.
Youcanadjustthevarioussettingssuchas
audiobalanceorsubwooferlevel.
1
Touch [Menu] on any screen.
2
Touch [Audio].
Audio screen appears.
See the following section for each setting.
• Setting audio (P.82)
• Controlling audio (P.86)
• Controlling equalizer (P.87)
• Performing zone control (P.89)
• Set space enhancer
(P.89)
• Set listening position
(P.90)
Setting Audio
1
Touch [Audio SETUP].
Audio SETUP screen appears.
See the following section for each setting.
• Set up speakers (P.82)
• Set up your car type (P.84)
• Select DSP
(P.85)
• Set up elevation (P.85)
Speaker Select screen appears.
• Set up speakers (P.82)
Speaker setup
Youcanselectaspeakertypeanditssizeto
getthebestsoundeffects.
Whenthespeakertypeandsizeareset,
thespeakercrossovernetworkisset
automatically.
1
Touch [Speaker Select] in the Audio
SETUP screen.
Speaker Select screen appears.
2
Touch the speaker you wish to adjust
and set each item as follows.
Controlling Audio
Subwoofer
Selectifyouareusingasubwoofer.
Tweeter
Youcansetthetweeterwhenyouare
selectingfrontspeakers.
Ifyouareusingatweetertogetherwiththe
frontspeakers,setthetweeterto“ON”.
X’over
Displaysthespeakercrossoversetupscreen.
Youcanadjustthecrossoversetupthatwasset
automaticallywhenyouselectedthespeaker
type.
Fordetails,seeCrossover network setup
(P.83)
3
Select a speaker size using [2] and
[3]. The speaker size is different
depending on the speaker type and
the unit.
Front
OEM,8cm,10cm,12cm,13cm,16cm,17cm,
18cm,4x6,5x7,6x8,6x9,7x10
Rear
None,OEM,8cm,10cm,12cm,13cm,16cm,
17cm,18cm,4x6,5x7,6x8,6x9,7x10
Subwoofer
None,16cm,20cm,25cm,30cm,38cmover
NOTE
•Select“None”ifyouhavenospeakers.
Front
Standard,Wide,Middle,Narrow
Crossover network setup
Youcansetacrossoverfrequencyof
speakers.
1
Touch the speaker to set the crossover
in the Speaker Select screen.
2
Touch [X’over].
X’over screen appears.
3
Set each item as follows.
Phase*
Setsthephaseofsubwooferoutput.
Thephaseisreversed180degreeswhensetto
“Reverse”.
HPF FREQ
HighPassFilteradjustment.(Whenfrontorrear
speakerisselectedonSpeakerSelectscreen)
LPF FREQ
LowPassFilteradjustment.(Whensubwoofer
isselectedonSpeakerSelectscreen)
Slope
Setsacrossoverslope.
*Thisfunctionisavailableinthespecific
situation.
Onlywhen“Subwoofer”issetto
otherthan“None”in“SpeakerSetup”.
Onlywhen“Subwoofer”is
setto“ON”in“SpeakerSetup”and“LPF
FREQ”issettootherthan“Through”.