[Unloading the film]
1. Press the shutter release button when
you have focused and
determined
compos-
ition.
2. Advance the film by winding the film
advance lever until it stops. (The shutter is
then cocked.)
3. After completing the last exposure, wind
the advance lever several times, until the
film with its backing paper is completely
wound onto the take-up spool. The advance
lever will become easier to actuate when
the film has been completely wound on the
spool.
*
When the shutter release button is pressed and
the film is exposed. a red LED will light on the
upper right side of the viewfinder.
1.
Open the back cover and remove the roll
of film. By pushing the spool stud release
lever to the right, disengage and remove the
spool. As shown, the roll of film can be eas-
ily removed from the take-up chamber if you
push the spool up a little-it will then lift
out. When the back cover is opened, the
exposure counter will automatically return to
‘S’
(start).
2. Be careful not to let the roll of exposed
film unwind. Be sure to seal it immediately
.
l
To prepare
for
another roll,
remove
the empty
spool from the film
chamber, and
place it in the
take-up chamber.
*
Wind the advance lever until it stops. (Other-
wise a red
LED in the
viewfinder
will signal that
it
is
impossible to
press
the
shutter release button.)
l
Do not advance the film too quickly, as this might
adversely affect film flatness. or frame spacing.
*
To remove the film before exposing the entire
roll, cap the lens and press the shutter release but-
ton and wind the film onto the take-up spool frame
by frame.
22
