TV + cable with a decoder box
equipment you will need
Use this hook-up if you need a decoder box to descramble cable
channels. When you complete this hook-up, you should set up your
remote control to operate your cable box (see page 45).
To complete the hook-up, you'll need:
One two-way splitter, and
Three 75 ohm coaxial cables.
procedure
O Connect the incoming cable to tbe IN terminal on the two-way
splitter.
Connect a coaxial cable to one of the OUT terminals on the
splitter; connect the other end of this cablE,, to the ANT-A
terminal on the back of the TV.
Connect the second coaxial cable to the second OUT terTninal
on the same splitter; connect the other end of this cable to the
IN terminal on the decoder box.
Connect the third coaxial cable to the OU_? terminal on the
back of the decoder box, and the other end of this cable to the
ANT-B terminal on the back of the TV.
28 Chapter 2: Connecting Your TV
