3. ADSL Facility Commands
4200-A2-GB20-00 August 2002
3-11
adsl_nblk
(continued)
MXTXPWRDN: Specifies the maximum transmission power settings for
the ATU-C. The maximum transmit power range may be limited
according to local guidelines when spectrum management is enabled.
The values (configurable in 1 dB increments) supported are:
– +12 to −14dB (default is +12 dB), for all models when spectrum
management is disabled, for Canada models when EWL is 10 kft
or less, and for U.S. models with spectrum management enabled.
– +11 to −14dB (default is +11 dB) For Canada models with
spectrum management enabled when EWL is greater than 10 kft.
MXTXPWRUP: Specifies the maximum transmission power settings for
the ATU-R. The maximum transmit power range may be limited
according to local guidelines when spectrum management is enabled.
The values (configurable in 1 dB increments) supported are:
– +12 to −14dB (default is +12 dB), for all models when spectrum
management is disabled, for Canada models when EWL is
≤10 kft, and for U.S. models with spectrum management enabled.
– +11 to −14dB (default is +11 dB) For Canada models with
spectrum management enabled when EWL is >10 kft.
For the following parameters (ADSLPROF and ADSLPROFNM), both
cannot be specified.
ADSLPROF: The ADSL alarm profile index (1−30, default is 1)
ADSLPROFNM: The ADSL alarm profile name (default is NTDEFVAL)
The following parameters (ATMACCPROFF and ATMACCPROFFNM),
cannot be specified while any VPLs or VCLs exist.
ATMACCPROFF: ATM Access Profile Index for ADSL Fast channel (2)
ATMACCPROFFNM: ATM Access Profile name for ADSL Fast channel
If not specified, the values of these parameters remain unchanged.
[pst] Desired primary state. Valid values are:
IS: In-Service
OOS: Out-Of-Service (OOS-MA is implied)
If not specified, the value of this parameter remains unchanged.
Table 3-9. ED-ADSL Command Parameters (2 of 2)
ED-ADSL:[tid]:aid_adsl:[ctag]:::[adsl_nblk]:[pst];
