• The MEMORY button does not
function if REPEAT PLAY is ON.
Details are on page 39.
• To erase a real-time tape counter
memory, press MEMORY until the
M disappears from the screen.
• You may only set the real-time tape
counter to zero at one location at a
time. Setting the real-time tape
counter to zero at a second location
will erase the previous zero setting.
• If you remove the tape, the counter
will reset to zero at the point at
which you last stopped playback
whenever you reinsert the tape.
Helpful Hints
STOP 1:08PM
TV STEREO CH10
SLP 1 :23 : 45 HIFI
Follow the steps below to reset the real-time tape counter to
zero at a tape location you want to refer to later.
● Before you begin, place the DVD/VCR in VCR mode.
Press OUTPUT SELECT so the green VIDEO light appears on the
front of the DVD/VCR.
1
Press VCR, then play, fast forward, or rewind a tape
to the location that you would like to refer to later.
Press STOP C (p) to stop the tape.
2
Press DISPLAY/STATUS/EXIT to see the status dis-
play.
3
While the status display is on the screen, press
CLEAR to reset the real-time tape counter to zero.
STOP 1:08 PM
TV STEREO CH10
SLP 0 :00 : 00 HIFI
4
While the real-time tape counter is on the screen,
press MEMORY so M appears beside the counter.
STOP 1:08 PM
TV STEREO CH10
SLP M 0 :00 : 00 HIFI
5
To go to a tape location where the real-time tape
counter was reset to zero, press REW h (s) or
FF g (B) when playback is stopped.
When the tape reaches the point at which the counter was
set to zero, the tape will stop. Press PLAY B (o) to watch
the tape.
40 Real-Time Tape Counter Memory
2
3
4
5
1
VCR
H9231CD(EN).QX3 02.9.5 7:13 PM Page 40
