DIf any of the TIMER blocks are in use, ’k’ will light up
on the video recorder display.
DWhile a programmed recording is being made, you
cannot operate your video recorder manually. If you
want to cancel the programmed recording, press
STANDBY/ONm .
DIf you reach the end of the cassette during a
recording, the video recorder will automatically
eject the cassette.
DIf you forget to load a cassette, ’CASS’ will briefly
appear in the display and then ’k’ will flash in the
video recorder display.
DIf you have put in a cassette which cannot be used
for recording, the video recorder will automatically
eject it.
DIf ’FULL’ appears in the display when you press
TURBO TIMER , you have used up all the available
TIMER blocks. You can find more information on
how to clear or check a programmed recording
(TIMER block) in the next chapter.
How to check or change a programmed
recording (TIMER)
a Switch on the TV set and select the programme number
for the video recorder.
b Press TIMER k on the remote control twice.
c Select the programmed recording (TIMER) you want to
check or change with rP = or ;P q .
d Press TIMER k .
e Select the entry field with Q or P .
f Change any information with rP = or ;P q or with
the 0-9 number buttons.
g Confirm with OK .
h Make sure that the cassette you have put in can be
recorded on. Switch off with STANDBY/ONm .
DThe programmed recording will only function when
the video recorder is switched off with
STANDBY/ONm .
How to clear a programmed recording
(TIMER)
a Switch on the TV set and select the programme number
for the video recorder.
b Press TIMER k on the remote control twice.
c Select the programmed recording (TIMER) you want to
clear with rP = or ;P q .
d Press CLEAR(CL) .
The programmed recording (TIMER) has now been
deleted.
e To end, press MENU .
23
