Connecting the Controller 45
If you are using a Cable Box/DBS, connect the Controller to your VCR. The Controller will automatically
select channels at the Cable Box/DBS during a timer recording. Leave your Cable Box/DBS turned on
during a timer recording.
2
Connect the Controller to the CABLE BOX Jack on the back of the VCR as shown above.
3
Attach the Controller to the top of the VCR using the supplied adhesive. Make sure the
Controller’s transmitter (the light on the top of the Controller) is pointed toward the Cable Box/DBS
remote sensor.
4
If you are using a Cable Box, follow the steps on pages 46-47 to make the Controller change
channels at the Cable Box during timer recordings.
If you are using a DBS, follow the steps on pages 48-49 to make the Controller change
channels at the DBS during timer recordings.
1
Connect the Cable Box/DBS to the VCR as shown below. For more information, please read page
8. Or, refer to the owner’s manual of your Cable Box/DBS.
ANT. IN
ANT. IN
