SELECT CODE NUMBER
OF YOUR DBS RECEIVER
40
REFER TO
INSTRUCTION BOOK
TO SET PUSH , 9
TO TEST PUSH :/OK
TO END PUSH EXIT
48 Setting the Controller to Operate a DBS
• If you use a DBS, you must set the clock manually. Details are on
pages 15-16.
• Complete the steps on page 29 before proceeding. This will allow
you to use the VCR remote control to operate the DBS, and you
will learn your DBS code.
• The Controller can change channels
at the DBS only during a timer
recording.
Helpful Hint
1
Turn on the DBS. Select a
channel other than 205.
1
Turn on the DBS. Select a channel other than 205.
2
Press the VCR button, then press the MENU button.
3
Press the PLAY 8 or STOP 9 button to select INITIAL
SET UP, then press the FF :/OK button.
4
Press the PLAY 8 or STOP 9 button to select DBS
RECEIVER, then press the FF :/OK button.
5
Press the PLAY 8 or STOP 9 button to select the output
channel of your DBS receiver, then press the FF :/OK
button. The display shown below will appear. If DBS RECEIVER
USERS SET CLOCK MANUALLY appears, follow steps 4-8 on
page 16, then go to step 6 on page 49.
DBS RECEIVER CONTROLLER
OFF
A OFF
ON CH. 3
ON CH. 4
ON A/V FRONT
ON A/V REAR
SELECT , 9 CHOOSE :/OK
TO END PUSH EXIT
SELECT , 9 CHOOSE :/OK
A CLOCK
LANGUAGE ENGLISH
VCR PLUS+ CH.
CABLE BOX
DBS RECEIVER
TO END PUSH EXIT
3-5
2
SELECT , 9 CHOOSE :/OK
A VCR SET UP
TUNER SET UP
INITIAL SET UP
TO END PUSH EXIT
