Problem Solution
Perhaps the tap water pressure is higher than
specied.
You may need to wind some Teon tape around the
screw thread of the adapter.
The water
ow is weak at
the unltered
setting.
Perhaps the stainless steel screen under the rubber
washer inside the water purier housing is clogged.
Clean it with a soft brush and rinse it.
The water
ow is weak at
the ltered
setting.
Perhaps the lter cartridge is clogged. Replace the
lter cartridge.
Perhaps the tap water pressure is lower than
specied.
Perhaps you are using a lter cartridge whose
lifetime has expired. Replace the lter cartridge.
Air may be trapped inside the lter cartridge. This
may happen when you install a new lter cartridge.
To avoid this, slightly open the tap for 30 seconds
immediately after you install/replace the lter
cartridge. The slow stream of water removes any air
trapped in the lter.
The display
is empty after I
have replaced
the battery.
Perhaps the tap water pressure is lower than
specied.
Perhaps the poles of the battery point in the wrong
direction. Insert the battery in the correct way (see
section ‘Inserting the battery’ in chapter ‘Preparing
for use’).
ENGLISH 19
