A SERVICE OF

logo

The granular activated carbon removes the unpleasant chlorine smell
and taste from your tap water.
The LCD display on the water purier shows the current remaining
lter capacity. A remaining lter capacity of 0 tells you that you
have to replace the lter. Philips’ unique cartridge replacement
indicator also helps you to determine when to replace the lter.
The high-speed initial ow rate of 2 litres per minute gives you plenty
of clean water instantly.
The water selection lever offers you a choice of three water ow
types: unltered spray, unltered stream or ltered spray.
The nine tap-mounting adapters supplied with the water purier
allow easy installation on almost any type of tap.
The bayonet-type mount ensures quick, easy and secure lter
cartridge replacement.
Preparing for use
Inserting the battery
Before you insert the battery, make sure your hands and the water
purier are dry.
Keep away from the kitchen sink to prevent the battery from falling
down the drain.
Insert the battery before you install the water purier on the tap.
1 Use a coin to turn the battery compartment cover on the back of
the water purier in the ‘OPEN’ direction. Remove the battery
compartment cover (Fig. 2).
2 Place the battery (included) in the cover, with the + pole facing the
battery compartment cover (Fig. 3).
3 Place the battery compartment cover back onto the water purier
in such a way that the ‘
%’ mark on the cover is aligned with the ‘I’
mark on the water purier. (Fig. 4)
4 Use a coin to turn the battery cover in the ‘CLOSE’ direction until
the ‘I’ mark on the cover is aligned with the ‘I’ mark on the water
purier (Fig. 5).
-
-
-
-
-
-
-
-
-
ENGLISH 9