75
RESETTING/INITIALIZING THE
SCANNER
If the scanner’s display locks up or does not work proper-
ly after you connect a power source, you might need to
reset or initialize it.
Important:
If you have problems with the scanner, first
try to reset it to retain all memory. If that does not work,
you can initialize the scanner; however, initializing clears
all information stored in the scanner’s memory.
Resetting the Scanner
1. Turn off the scanner, then turn it on again.
2. Insert a pointed object, such as a straightened paper
clip, into the reset opening on the side of the scan-
ner. Then gently press and release the reset button
inside the opening and the backlight lights.
Note:
Pressing
RESET
does not clear the scanner’s
memory.
Initializing the Scanner
Important:
This procedure clears all information you
stored in the scanner’s memory. Initialize the scanner
only when you are sure the scanner is not working prop-
erly.
1. Turn off the scanner, then turn it on again.
Wel-
come
To
Multi-System
Trunking
appears
on the display.
Reset
20-522.fm Page 75 Friday, September 17, 1999 12:46 PM
