© 2000 Robinair, SPX Corporation
2
Set-Up Instructions
SET-UP INSTRUCTIONS
The unit comes with four 60” Enviro-Guard hoses with ball valves.
Either blue hose may be used where blue hose connections are called for, and either
red hose may be used for red hose connections.
CAUTION! Be sure ball valves on hoses are in the closed position before
connecting them.
1. Connect the hoses as follows:
Hose Standard End connects to: Ball Valve End connects to:
Blue Hose TANK LIQUID fitting on unit LIQUID port on tank
Red Hose TANK VAPOR fitting on unit VAPOR port on tank
Blue Hose SYSTEM VAPOR fitting on unit SYSTEM VAPOR port
Red Hose SYSTEM LIQUID fitting on unit SYSTEM LIQUID port
2. Plug the unit into the proper electrical outlet. The fan starts running
immediately.
The unit is ready for operation.
OPERATING GUIDELINES
• The voltage at the unit must be +10% of the unit’s rated voltage.
• Extension cords must be a minimum of 14 AWG and kept as short as possible.
• To minimize mixing of refrigerants, the self-clearing procedure must be performed
after each recovery operation.
• The low side gauge on the unit allows you to monitor system pressure and stop
recovery when a deep enough vacuum has been reached. The high side gauge on the
unit allows you to monitor the refillable tank pressure.
• When changing from liquid to vapor, the unit may switch back and forth several
times before staying on vapor. You may notice the liquid and vapor lights switching
and hear the solenoids opening and closing. This is normal and does not affect the
unit or its operation.
POWER CORD
The power cord used for this unit must meet the following requirements:
• 10A/250VAC IEC 320 Connector
• 3 x 1.00mm Harmonized cordage, HO5RNF3G1.0, 32/.2MM Stranding,
<HAR>, Black Jacket, Max. Temp 65C
• 10A/250VAC Plug
