Transmission Fluid Exchanger
1313
1313
13
Operating Procedures
Total Count
Displays the number of ATF exchanges
performed.
Power Up
1. Connect the power cord to a 12V DC
battery: red to the positive post and black to
the negative post.
2. Turn the unit on. The
Reversed Polarity
LED
lights if the power is connected incorrectly.
The unit self-tests: The buzzer sounds, all
LEDS and displays light and flash, the
flexible nylon hose evacuates ATF, and the
software version displays.
Start Service
1. Press the SELECT button until only the
Total
Count
LED is lit and flashing.
2. Pause until the ENTER LED lights and
flashes (about one second).
3. Press ENTER to confirm the selection.
The total number of services performed is
displayed; the
Finish
LED flashes.
4. Press ENTER to return to mode selection
after noting the total number of services.
Changing Transmission
Fluid Types
To change transmission fluid type in a new tank:
1. Connect the power cord to a 12V DC
battery: red to the positive post and black to
the negative post.
2. Insert the flexible nylon hose into a clean
ATF container.
3. Press the SELECT button until
Manual/Top-
Off
LED lights.
4. Press ENTER.
5. Press the SELECT button until
To Trans
LED
lights.
6. Press ENTER.
7. Press the UP arrow key until display reads
an amount more than what is in the new
tank.
8. Press ENTER. The unit will pump ATF from
the new tank into the clean ATF container.
9. Turn the unit off when completed. The unit
will clear the lines when it is restarted.
