18
ᕥ
ᕧ
PUTTING THE RECEIVER INTO OPERATION
Charge the accupack for 24 hours before you use it for the first time!
̈ Take your stethoset receiver out of the charging compartment ³ on the transmitter.
̈ Have you charged the accupack separately from the stethoset receiver?
Then insert the accupack into compartment ² in the receiver.
SWITCHING ON THE RECEIVER
Use control ´ to switch on the receiver and adjust the volume.
ADJUSTING THE RECEIVER CHANNEL
Transmitter and receiver have to operate on the
same frequency:
̈ Put the transmitter and the receiver into
operation as described above. Switch on the
TV set! If possible, switch off its loudspeakers.
̈ Use switch µ on the transmitter to select a
transmission channel.
̈ Set the volume control ´ on the receiver to a
medium value (position 3–4).
̈ Slowly turn control ¶ (“TUNE”) on the
stethoset receiver until you can hear the audio
signal loud and clear. The receiver’s AFC
(Automatic Frequency Control) circuitry
stabilises your adjustment.
Transmitter and receiver are now operating
on the same frequency.
