Feature Enable/Disable:
Speaker
The Olé-2SF contains a small
speaker that allows audible feed-
back signals to be heard as a result
of button pushes. This feature can
be disabled in the SunTools setup
software.
IR Sensor
The Olé-2SF features a built-in IR
Sensor. IR signals from a hand-held
IR remote control pass through the
IR sensor and travel to the head-
end location where they control
IR sources located there. These
sources may be connected to a 3rd-
party Multi-Zone Controller or an IR
distribution network.
The IR Sensor can be disabled in
SunTools setup software.
Light Sensor Enable/Dis-
able
The Olé-2SF touchpad has a light
sensor feature.
1. Install the unit in the wall, using
the wall plate that will be used in
the nal installation.
2. Adjust the room lighting to the
brightest setting possible.
3. Select a source on the touchpad.
The light sensor function only
works when the unit displays the
source icon screen.
4. Press and hold the "SELECT" but
-
ton for ve seconds. Depending
on the correct state of the sensor,
a message will be displayed:
“Release button to ENABLE
sensor”
or
"Release button to DISABLE
sensor"
Once the button is released, a
conrmation message will be sent:
Either:
"LIGHT SENSOR ENABLED"
or
"LIGHT SENSOR DISABLED"
When the Light Sensor is enabled,
the Olé-2SF touchpad's backlight
will brighten or dim depend-
ing on the room's ambient light
conditions. When the sensor is
disabled, the Olé-2SF remains at
full brightness no matter what the
ambient light conditions are like.
19
