2
To view these pages, use the coloured prompt buttons,
e.g. press the Green button to view page 200.
3
If you want to change the stored pages, press the
coloured button for the colour you want to change,
e.g. press the Green button and enter the 3-digit
number.
This number will change in the top left of the screen
and in the coloured highlight.
4
Press
Q
to store your choice.
5
You may view other pages by simply entering the
3-digit page number – but NEVER press
Q
or you
will lose the favourite already stored.
Teletext buttons on the remote control
Below is an introduction to the teletext buttons on your
remote control and their functions.
k
To display the index/initial page:
In Auto-mode
Press
k
to access the index page. The one displayed is
dependent on the broadcaster.
In LIST-mode
Press
k
to return to the 100 page or initial page.
A
To reveal concealed text:
Somepagescovertopicssuchasquizzesandjokes.To
discover the solutions, press
A
.
B
To hold a specific page:
At times it is convenient to hold a page of text. Press
B
and
B
will appear in the top left of the screen. The page
will be held on screen until the button is pressed again.
C
To enlarge the teletext display size:
Press
C
once to enlarge the top half of the page, and
press again to enlarge the bottom half of the page. Press
againtoreverttothenormalsize.
D
To select a page while viewing normal
picture:
When in teletext mode, if a page selection is made and
then
D
is pressed, normal picture will be displayed.
The TV will indicate when the page is present by
displaying the title bar of the text page at the top of the
screen. Press
i
to view the page.
Note:
It will not be possible to change TV channels while
in Teletext mode. You will have to cancel Teletext
first by pressing
i
to return to normal TV picture.
To select the time display
- analogue only -
:
If you press
D
while watching a normal TV
broadcast, you will see a time display from the broadcaster.
It will remain on the screen for about 5 seconds.
Subtitles
1
Press
h
on the remote control to display the current
Subtitle status. While this status is displayed, press
again to change the setting.
2
If you switch off the TV, the
Subtitle
mode will be
remembered the next time the TV is switched ON.
Notes :
• If
Subtitle
is On, the TV will always display subtitles
whenever such information is available for the
channel you are viewing. In DTV mode, you may
use on-screen information to check if subtitles are
currently available.
• You may also enter Subtitle mode by directly
entering page 801 in Teletext. However, by doing
so, the TV remains in Teletext mode, and you
cannot change the channels. This is becausew
P
U
and
P
u
will change Teletext pages rather than
channels. To view subtitles, it is recommended that
you turn on Subtitle mode directly by pressing
h
on the remote control while watching TV.
