Toshiba B-850 Manual

A SERVICE OF

next previous

2. PRINTER SETUP

EO1-33029

2.3 Assembling the Accessories

2- 3

2.3 Assembling the

Accessories

2.3.1 Assembling the

Supply Holder Frame

The following procedure outlines the steps required to assemble the

Supply Holder Frame and attach the frame to the B-852 printer in

preparation for loading the media.

1.

Assemble the Supply Holder Frame (L) and Supply Holder Frame (R)

to the Supply Holder Base using the two M-4X6 Wing Bolts supplied,

as shown below.

2.

Attach the assembled Supply Holder Frame to the rear of the B-852

printer by inserting the hooks of the Frame into the two slots in the

rear of the printer as shown in the figure below.

NOTE:

M

ake sure that the two small

f

langes at each end of the

Supply Holder Base fit into the

small rectangular holes at the

bottom of the Supply Holder

Frames before tightening the

Wing Bolts.

NOTE:

A

fter attaching the supply

holder frame to the printer,

make sure that it is assembled

f

irml

y

.

Suppl

y

Holder Frame

(

L

)

Suppl

y

Holder Frame

(

R

)

Wing Bolt

Wing Bolt

Supply Holder Base

Hook

Hook