TL-WR700N 150Mbps Wireless N Mini Pocket Router
- 8 -
Figure 2-3 Hardware Installation of the TL-WR700N in Repeater Mode
1. Plug the power plug of TL-WR700N in electrical wall socket.
2. Power on the notebook(s).
)
Note:
It is recommended that you connect a PC/notebook to the LAN port of the Router with an Ethernet
cable, and then login the Router from the PC/notebook to set the Router in AP Repeater mode.
2.3.4 Bridge Mode
Similar to the Bridge mode, TL-WR700N in Bridge mode is also used to extend the range of
wireless signal of the existing AP or wireless router.
On this mode, the only wired port works as LAN. Computer could connect to the device by either
wired or wireless way. To avoid the conflict of DHCP service with front-end devices, the DHCP
server is default to be closed on this mode. If you want to log in the management page, please set
your computer’s IP address manually.
Figure 2-4 Hardware Installation of the TL-WR700N in Bridge Mode
