Replacing the Internal Hard Disk
Tyros3 Owner’s Manual • 105
5 Remove the four screws to remove the installed hard disk unit
from the bracket.
6 Attach the new hard disk unit to the bracket using the four
screws removed in step 5.
7 Set the Tyros3 right-side up.
8 Insert the hard disk bracket into the slot.
9 Turn the Tyros3 face down again and fasten the three screws
removed in step 3.
10 Check that the installed hard disk is functioning properly.
Set the Tyros3 right-side up, and turn the power on. If the HD tab appears on the
File Selection display, the hard disk is OK.
You should tighten these two
screws first.
Make sure the bottom of the hard disk is facing up.
Depending on the type of hard disk drive you plan to
install, select holes A or holes B to attach the hard disk
drive.
* Holes A are used in this illustration.
If you have installed the hard disk that
was once used for the Tyros/Tyros2 and
turn the Tyros3’s power on, you can
immediately view the files on the hard
disk and use the Song files from the
Tyros/Tyros2. However, to properly use
the Style, Multi Pad, and Registration
Memory files from the Tyros/Tyros2,
you will need to convert the data using a
computer and the File Converter soft-
ware (available for free download on the
Tyros3 website).
NOTE
