Filter
Top Products
Installing Options
12
2
2.
Large Capacity Tray RT36
Holds up to 1500 sheets of plain pa-
per. (80 g/m
2
, 20 lb. bond)
If you want to install the Large Capac-
ity Tray RT36, contact your sales or
service representative.
3.
Bridge Unit Type1045
This unit is necessary when using the
Finisher or the Mailbox.
If you want to install the Bridge Unit
Type1045, contact your sales or serv-
ice representative.
4.
Finisher SR720
If you want to install the Finisher
SR720, contact your sales or service
representative.
5.
Finisher SR730
If you want to install the Finisher
SR730, contact your sales or service
representative.
6.
Mailbox CS360
If you want to install the Mailbox
CS360, contact your sales or service
representative.
Note
❒ The Bridge Unit Type460 is required
when you install both the Finisher
SR730 and the Mailbox CS360.
❒ To use the punch function with the
Finisher SR730, the Punch Kit
Type450 is required.
❖
❖❖
❖ Interior
1.
Slot for the Memory Unit TypeC
Install the memory unit into the slots
in the printer board. There are three
types of Memory Unit TypeC, 64 MB,
128 MB and 256 MB. Only one of them
can be installed at once. ⇒ p.14 “In-
stalling Memory Unit TypeC”
2.
Slot for the 1394 Interface Unit
Type 4510
You can perform the print job on the
IEEE1394 environment.
⇒ p.22 “Installing 1394 Interface Unit
Type 4510”
3.
Printer Hard Disk Type4510
Install the HDD into the slot in the
printer board.
⇒ p.18 “Installing Printer Hard Disk
Type4510”
Note
❒ When you install several different options, be sure to install the Paper Bank
PS430 first.
1 2
3
Setup-F3_FM.book Page 12 Friday, October 5, 2001 8:27 PM