Filter
Top Products
© December 2004, ADIC 11
Sony SDX-700C
(AIT-3)
X X X X Requires
minimum FW
level 0102
Sony GY-2120
(DTF-1)
X X Requires
minimum FW
level 1.10
X Requires
minimum FW
level 1.10
Sony G4-8240
(DTF-2)
XXXX-
StorageTek
Timberline 9490-E
XX ---
StorageTek
Redwood SD-3
XXX--
StorageTek 9840
A, B, and C
XXXSee Note 2-
StorageTek 9940 A
and B
XXXSee Note 2-
1
For more information about the AMASS volformat and driveclean commands, refer to the Command Reference
chapter in Managing the AMASS File System. Drive Cleaning exceptions are noted under the specific
libraries in Accessing Storage Devices.
2
For more information about the AMASS config_prod -o script, refer to the Optional Parameters appendix in
Installing
AMASS.
3
For more information about IFL, refer to the InfiniteFileLife book.
* DLT customers: ADIC recommends that you enable the Tape Streaming feature. Using tape streaming
I/O eliminates start/stop cycles on these drives, which leads to better tape handling. For instructions on
configuring AMASS for tape streaming, refer to the Optional Parameters appendix in Installing AMASS.
Note 1: If a 3590 OR 3592 drive is installed in an IBM 3494 library, automatic drive cleaning by
AMASS is not supported because the library has its own internal drive cleaning capabilities.
Note 2: If a DLT or StorageTek 9840 or 9940 drive is installed in a StorageTek 97xx or Lxx library,
automatic drive cleaning by AMASS is not supported because the library has its own internal drive
cleaning capabilities.
Tape Drives
Configure
Block Size
(volformat
command)
1
Compression
(volformat
command)
1
Tape
Streaming
(config_
prod -o)
2
Automatic
Drive
Cleaning
1
Optional
InfiniteFile
Life
3