Filter
Top Products
I - Trouble Shooting Guide
J - Installation instructions
INFORMATION FOR THE INSTALLER
THE GRAB HANDLES MUST BE USED TO MOVE THE OVEN.
WHEN THE OVEN IS HALF FITTED IN THE CABINET, IT IS POSSIBLE TO REMOVE THE
TWO HANDLES BY UNSCREWING THE FOUR FIXING SCREWS.
DO NOT LIFT OVEN BY THE FRONT DOOR AS THIS WILL DAMAGE THE OVEN
The operations indicated below must be followed by qualified personnel, in conformity with the regulations
in force.
The supplier refuses all responsibility for damages to person or property, resulting from
the failure to comply with such provisions.
All units are 230/240 power and 60hz
The appliance is designed to be used near heat resistant pieces of furniture or kitchen cabinetry
only.
ELECTRICAL CONNECTIONS (FIG.7)
Before carrying out electrical connection, be sure that the characteristics of the electrical system
meet the specifications located at the bottom of the cooktop and the electrical system is provided
with effective ground in compliance with the regulations and provision of the law in your country.
The ground is required in all circumstances.
If you wish a direct connection to the line, it is necessary to use a single pole switch, with a
minimum opening between the contacts of 3 mm. suitable for the purpose and in conformity with
the rules in your country (the yellow/green ground cable should not be interrupted by the switch).
Symptom Remedy
No power supplied to appliance Has the power been disconnected? Check the meter
box. Has the main fuse or circuit breaker blown or
tripped?
Oven power is on but appliance does not
operate
Oven may be set on AUTO (see auto programmed
cooking)
Oven power is on but there is no heat Oven may be set on AUTO
Oven temperature may be set OFF
Mode may be on incorrect selection
Rubber seal has gap/s at bottom and
ends do not meet
Correct - doors are sealed this way for oven venting
purposes
Display is flashing, is only part
illuminated or is cycling through various
displays.
Turn power supply to appliance off, wait 30 seconds and
turn power on. Reset clock