AEG 3210 BU Double Oven User Manual


 
28
CLEANING THE TOP OVEN ROOF
The grill element is hinged to make cleaning the oven
roof easier.
Switch off the appliance from the
electricity supply before cleaning and
ensure the oven is cold.
1. Remove the wirework side runners. See below.
2. Undo the two screws which hold the grill element
in place.
3. Gently pull the element downwards to allow
access to the oven roof. Do not force the element
downwards.
4. Clean the top of the oven with Cif cream cleaner
and a sponge scourer. If heavily soiled, aerosol
oven cleaners may be used following the
instructions given above for cleaning the grill / top
oven compartment.
5. Gently push the grill element back into place.
6. Fit the screws to hold the element in place and
tighten firmly.
7. Replace the wirework side runners.
Ensure the screws are firmly in place after
cleaning.
TO REMOVE THE WIREWORK RUNNERS
The wirework runners in both ovens can be removed
for cleaning.
1. Remove all shelves and furniture from the oven.
2. Hold the wirework at the bottom, unclip from the
cavity side and gently pull towards the centre of
the oven.
3. Support the side panel at the bottom.
4. Unhook the runner and side panel at the top and
remove from the cavity.
5. To replace, ensure the side panel is assembled
on to the wirework runner before hooking it back
into the oven.
Ensure that the wirework runners are firmly
in place before refitting the oven shelves.
CAVITY
CENTRE
SIDE PANEL