Filter
Top Products
Warnings about electrical connection
l Any electrical work required to install this hob should be carried out
by a qualified electrician or competent person, in accordance with
the current regulations.
l Before the appliance is connected:
1) check that the main fuse and the domestic installation can support
the load;
2) check that the power supply is properly earthed in compliance with
the current rules;
3) check the socket or the double pole switch used for the electrical
connection can be easily reached with the appliance built in the
forniture unit.
l
l
This hob has been registered as a Class Y appliance according to
Fire Risk Protection Regulations. It can be built-in in furniture units
placed near higher walls or units, provided that one of the sides is
adjacent to an unit with the same height.
l If connecting the hob directly to the power mains, a double pole
switch should be fitted, with a minimum gap of 3 mm. between the
switch contacts and of a type suitable for the required load in
compliance with the current electric regulations. The switch should
be sited within 2m of the hob and be easily accessible upon
completion of the installation.
l Proper arrangements must be taken in designing the furniture unit,
in order to avoid any contact with the bottom of the hob which can
be heated when it is operated. Before any intervention, ensure the
hob is disconncted from the electricity supply.
l Once connection has been carried out, test heating elements for
about 3 minutes.
l The minimum distance combustible material can be fitted above the
hob in line with the edges of the hob is 420 mm.
l It is not allowed to install an oven under the hob.
Installation
14
This hob is designed to be connected to a 230V single-phase 50 Hz AC
220 V, 60 Hz electrical supply.