Filter
Top Products
30
20 min
a
Removable
panel
Securing the hob into the cut out
Proper arrangements must be taken in
designing the furniture unit, in order to
avoid any contact with the bottom of the
hob which can be heated when it is
operated.
The recommended solution is shown in
diagram.
The panel fitted under the hob should be
easily removable to allow easy access if
technical assistance is needed.
50
Before fitting the hob into the cut out, the sealing gasket supplied with the
hob must be fitted to the edge of the cut out. It is essential that no gaps are
left in this seal in order to prevent spillage near the hob seeping into the
cabinet below.
1) Place the sealing gasket (A)
all around the edge of
the cut out.
2) Fit the hob in the cut out
and push it down until
it comes in contact with
the kitchen top surface.
The remove the excess
sealing.
3) To remove the hob from
the cut-out, lift the edge
of the hob by means of
the edge of a screw-
driver.