Filter
Top Products
Electrical connection
This hob is provided with a connection cable type H05 V2V2-F T90,
section 3 x 1,5 mm
2
. A suitable plug must be fitted to the cable and
then connected to a suitable plug, according with spexcification given
on the rating plate.
If connectiong the hob directly to the power mains, a double pole
switch should be fitted, with a minimum gap of 3 mm. between the
switch contacts and of a type suitable for the required load in
compliance with the current electric regulations.
The switch must not break the yellow and green earth cable at any
point.
Ensure that the hob supply cord does not come into contact with
surfaces whose temperature exceed 90°C over room temperature..
Replacement of connection cable
The connection of the voltage cable to the appliance's terminal block
is of type "Y". This means that its replacement requires the specific
equipment of a technician.
In this case, only cable type H05V2V2-F T90 must be used. The cable
section must be suitable to the voltage and the working temperature.
The yellow/green earth wire must be approximately 2 cm. longer than
the phase wires .
To open the terminal block and reach
the terminals, proceed as follows:
1) insert the point of a screwdriver into
the visible protrunding part of the
terminal block;
2) exert a light pressure and lift.
15