Filter
Top Products
29
Proceed as follows:
Remove the machine’s worktop by unscrewing the two rear retaining screws,
pull from the front and slide out the slots, lifting the worktop.
Insert the machine after adjusting the level with the adjustable feet.
When inserting the machine, ensure that the water inlet and drain hoses are
not kinked or squashed.
Connecting the water supply
Your dishwasher has been built in accordance with the valid regulations
governing water-consuming appliances and is equipped with safety devices
which prevent used water from flowing back into the drinking water mains.
Your dishwasher can be connected to either a cold or hot water supply of
max. 60°C.
Never connect your dishwasher to open hot water appliances and continuous
flow heaters!
The supply hose is fitted with a screwed hose connection (to DIN 259) and
can be connected to an outlet valve (water tap) with male thread (3/4").
Suitable washers are supplied with the machine. Do not use any washers
other than these!
The nut of the screwed hose connection can be tightened by and. If you re-
quire a supply hose which is longer than the one supplied, use only the VDE-
approved complete hose kit (obtainable from our service centre) continuously
and to adequate length.
Never lengthen existing hoses.
Important note! The supply hose must not be kinked, squashed, or twisted.
Please ensure careful running.
To avoid reductions in water supply to the kitchen, we recommend you to
install a separate tap. Failing this, fit a branch piece to the existing water tap.
Additional installation expenditure (on the building side) can be reduced by
use of conventional sink mixers with connection and shutoff valve.