Filter
Top Products
Installation and Connection Instructions
30
INSTALLATION AND CONNECTION
INSTRUCTIONS
Installing the Dishwasher
• The dishwasher must be installed on a firm floor and adjusted such
that it is stable and level.
• Using the spanner supplied, extend the threaded feet to compensate
for unevenness in the floor and to adjust the height of the appliance
to suit the surrounding units. In the case of dishwashers that can be
built-in or integrated, the rear feet on the appliance are adjusted at
the front of the appliance using a screwdriver.
• The drain hose, inlet hose and mains cable must be laid such that
they are free to move in the rear of the plinth recess, so that they
cannot be kinked or crushed.
• In addition, the dishwasher must be firmly screwed to the work sur-
face or to the neighbouring units. This is essential to guarantee the
tipping security required by VDE regulations.
• Depending on type, the dishwasher is to be installed as follows:
Dishwashers That Can Be Integrated
(see installation stencil supplied)
3
The door of the appliance can be fitted with a wooden/facing panel of
the following dimensions:
1
If the facing panel is longer than 600 mm, the door of the appliance
cannot be fully opened (the facing panel will foul on the plinth).
In this case a cut-out must be made in the plinth (see installation sten-
cil) or the stop kit for a door of excess length, BLT 60, used. You can
obtain this under E-No. 911 239 008.
Width: 591 – 594 mm
Thickness: 16 – 24 mm
Height: max. 600 mm
depending on
– Recess height
– Plinth height
– Adjustment to match the joint on the neighbouring
units
Weight: max. 8 kg