Filter
Top Products
Installation and Connection Instructions
35
Leak Prevention System
For protection from damage due to water leaks, the dishwasher is
equipped with a leak prevention system, the AQUA CONTROL SYSTEM.
In the event of a fault, the safety valve immediately interrupts the sup-
ply of water to the appliance and the drain pump switches on. By this
means water can neither escape nor overflow. The remaining water in
the appliance is automatically pumped out.
1
The AQUA CONTROL SYSTEM also works when the appliance is switched
off – the appliance must however not be disconnected from the mains.
Electrical connection
1
In accordance with the conditions of the electricity supply companies
in respect of the technical aspects of making connections to the mains,
fixed connections to the mains may only be made by approved electri-
cians.
When connecting up the appliance, observe the VDE regulations and, if
necessary, any additional conditions from your local electricity supplier.
Following installation, live parts and wiring insulated during operation
must not be accessible using a test finger in accordance with
EN 60335/DIN VDE 0700.
Information on the electrical connection can be found on the rating
plate on the inner edge of the dishwasher door on the right. If the
appliance has a change-over switch, the additional instructions on the
change-over diagram in the mains socket must be observed.
Prior to connecting up ensure that the mains voltage and type of sup-
ply match the nominal voltage and type of supply given on the rating
plate. The required level of protection is also to be found on the rating
plate.
To isolate the dishwasher from the mains, pull the mains plug. If the
appliance is permanently connected to the mains, then it must be iso-
lated from the mains using measures provided in the electrical installa-
tion (fuses – unscrew screw-type fuses, cut-outs, current trips or
similar that have a contact separation of > 3 mm when open).