AEG 6281 I Dishwasher User Manual


 
Operating instructions
28
...Error Messages Are Displayed.
If fault code (2 is displayed on the multi-display or the ^ indicator
is illuminated, you can probably rectify the fault yourself.
After rectifying a (2 fault and a fault related to the
^ indicator,
press the button for the wash programme that has been started. The
wash programme continues. If the fault code is displayed again, con-
tact customer service.
For all other faults, please contact customer service, stating the fault
code.
Malfunction Possible Cause Remedy
The programme indica-
tor for the selected
programme is flashing
and the
^ indicator is
illuminated:
there is no water run-
ning into the dish-
washer.
Tap is closed. Open tap.
The filter (where present) in
the threaded hose fitting at
the water inlet valve is
blocked.
Clean the filter in the
threaded hose fitting.
The water inlet hose is not
correctly laid.
Check hose installation.
Fault code (2 is dis-
played on the multi-
display.
The programme indica-
tor for the selected
wash programme is
flashing.
The siphon is blocked. Clean siphon.
The water drain hose is not
correctly laid.
Check hose installation.
Fault code (3 is dis-
played on the multi-
display.
The leak prevention system
has been triggered.
Close the tap and contact
customer service.
The [ indicator is
illuminated.
The [ indicator is only
intended to remind you to
check the filter in the dish-
washer from time to time
and, if necessary, to clean it.
It illuminates at regular
intervals, independent of the
amount of soiling of the fil-
ter.
The indicator goes out auto-
matically on the start of the
next wash programme.