g
54
«INSERT WASTE COFFEE
CONTAINER»
• The waste coffee container has pro-
bably not been replaced after cleaning.
0 Open the service door and insert the
waste coffee container.
«ADD PRE-GROUND
COFFEE»
• With the ground coffee function
selected, ground coffee has not been
poured into the ground coffee filler.
0 Add the ground coffee as described in
chapter „Using pre-ground coffee“,
page 43.
«FILL BEAN CONTAINER»
• The coffee beans have run out.
0 Fill the coffee bean container, see „Fill-
ing the coffee bean container“,
page 38
• If the coffee grinder is very noisy, this
could mean a small stone in the coffee
beans has blocked the grinder.
0 Contact the Customer Service Centre.
«PLEASE DESCALE !»
• This indicates the presence of limescale
in the appliance.
0 The descaling procedure, described in
the section „Running the descaling
program“, page 52, needs to be per-
formed as soon as possible.
«CLOSE DOOR»
• The service door is open.
0 Close the service door. If the service
door cannot be closed, check that the
brewing unit is inserted correctly (see
„Cleaning the brewing unit“, page 51)
«INSERT BREWING UNIT!»
• The brewing unit has probably not
been replaced after cleaning.
0 Insert the brewing unit; see „Cleaning
the brewing unit“, page 51
«GENERAL ALARM»
• The inside of the appliance is very dirty.
0 Thoroughly clean the inside of the
appliance; see „Cleaning the brewing
unit“, page 51. If the message is still
displayed after cleaning, contact the
Customer Service Centre.
17 Problems that can be
resolved before calling the
Customer Service Centre
If the appliance is not working, the
causes of the malfunction can be iden-
tified and resolved by referring to
chapter „What to do if you read fol-
lowing messages on the display ...“,
page 53. If, on the other hand, no mes-
sage is displayed, run the following
checks before calling the Customer
Service Centre.
The coffee is not hot
• The cups have not been preheated.
0 Pre-heat the cups by rinsing them in
hot water or leaving them for at least
20 minutes on the heated cup rack (H)
(see „Tips for making hotter coffee“,
page 42).
• The brewing unit is too cold.
0 Heat the brewing unit by selecting the
rinsing program before making coffee
(see „Running the rinsing program“,
page 42).
The coffee is not creamy enough
• The coffee is ground too coarsely.
0 Turn the knob for setting the grinding
texture one click anticlockwise (see
„Setting the grinding texture“,
page 46).
• Wrong type of coffee.
0 Use a type of coffee for fully automa-
ted espresso makers.
The coffee runs out too slowly
• The coffee is ground too finely.
0 Turn the knob for setting grinding tex-
ture one click clockwise (see „Setting
the grinding texture“, page 46).
822_949_344 CG6400.book Seite 54 Mittwoch, 25. Oktober 2006 12:38 12