AEG M 2600 Blender User Manual


 
g
10
g
Dear Customer,
Please read these instructions carefully.
Pay special attention to the safety in-
structions on the first pages. Keep the
instructions in a safe place for future
reference. Give them to any new owners
of the appliance.
Description (Figure 1)
A Tank
B Pouring outlet
C Filler hole with cup (locking)
D Lid
E Blade assembly
F Rubber seal (in blade assembly)
G Motor housing
H Pulse-Button
J Speed selector
K Non-slip feet
L Cord storage drawer
(on the bottom of the appliance)
M Rating label
(on the bottom of the appliance)
1 Safety Instructions
AEG electrical appliances meet the rec-
ognised technical and legal standards
for safety. As the manufacturers, we
nevertheless feel we should bring to
your attention the following points on
safety.
General Safety
The appliance should only be con-
nected to mains supplies with the same
voltage and frequency ratings as those
indicated on the Ratings Label.
Never pull the plug out of the power
socket by pulling on the cord.
Never try to operate the blender if
the casing has been damaged,
the cord has been damaged.
If the power cord for this appliance has
been damaged, it should only be
replaced, for safety reasons, by the
manufacturer or Customer Service, or
by a suitably qualified person.
The appliance should only be repaired
by a suitably skilled repair technician.
Inappropriate repairs may cause con-
siderable safety hazards. If repairs
become necessary, contact AEG Cus-
tomer Service, or your dealer.
Child Safety
Do not leave the appliance running
while unattended, or let children near
the appliance unsupervised!
When operating the appliance:
Never operate the appliance with your
hands bare.
Plastic parts should never be dried at
or near direct sources of heat.
The appliance must not be used for
mixing dyes (paints, or lacquer, etc,).
This can cause explosions!
When you have finished using the
appliance, before cleaning, switch off
and pull the plug out of the socket.
The blade assembly should only be dis-
assembled by an authorised technician.
Never clean the motor casing under
running water or soapy water.
Caution! The blade assembly is very
sharp. Be careful when taking the
blender apart and re-assembling. It
may cause injury if handled incor-
rectly
Do not leave hard objects (for example
spoons) in the blade assembly while
running, and do not grasp the appli-
ance with the hand inside the blender
tank. This may cause injury!
The manufactuer will not be responsi-
ble for any damage due to inappropri-
ate use or incorrect operation.