Filter
Top Products
61
How to change the bulb
Should the light fail to work you
can change it as below:
Break the circuit of the appliance.
Unscrew the screw holding the
cover (1), press the rear hook (2)
and at the same time slide the
cover in the direction indicated by
arrow (3). So the bulb can be
replaced. (Bulb type: 230-240 V,
15 W, E 14 thread)
After changing the bulb replace the cover, snap it in place, screw back the
screw and apply voltage to the appliance.
Electrical connection
This refrigerator is designed to operate on a 230 V AC (
~
) 50 Hz supply.
The plug must be put into a socket with protective contact. If there is no
such, it is recommended to get an electrician to fit an earthed socket in
compliance with standards near the refrigerator.
This appliance complies with the following E.E.C. Directives:
73/23 EEC of 19.02.73 (Low Voltage Directive) and subsequent modifica-
tions,
89/336 EEC of 03.05.89 (Electromagnetic Compatibility Directive) and
subsequent modifications.
- 96/57 EEC - 96/09/03 (Energy Efficiency Directive) and its subsequent
amendments