Filter
Top Products
I. TO REMOVE ELECTRODES (LHR, CF, RHR, RHF BURNERS)
1. Isolate from electric supply.
2. Proceed as ‘TO REMOVE THE HOTPLATE’.
3. Proceed as ‘TO REMOVE SPARK GENERATOR’ disconnect the appropriate electrode
lead.
4. Withdraw clip securing electrode to burner and withdraw lead and electrode (See Fig. 29).
5. Re-assemble in reverse order.
J. TO REMOVE ELECTRODES (LHF AND CR BURNER)
1. Isolate from electrical supply.
2. Proceed as ‘TO REMOVE HOTPLATE’.
3. Proceed as ‘TO REMOVE SPARK GENERATOR’.
4. Disconnect burner pipe (1/2”) and remove screws (2) fixing burner to support (Fig. 30).
5. Turn burner over and remove electrode fixing clip (Fig. 31). Remove spring and withdraw
electrode through top of burner checking on route of lead.
6. Re-assemble in reverse order, re-routing lead along the same path.
56
DESN 511649
DESN 512921
Fig. 29
Fig. 30