Filter
Top Products
00000000 Rev A. 4-06
www.airkinglimited.com 4 of 20
Grease Filters: Reinstall all grease filters by sliding tab at rear of
filter into slot in hood. While holding in handle of filter, lift filter
into palce and release handle. the filter should snap securely
into place (Figure 10).
NOTE: If your model is equipped with a filter screw, slide tab at rear
of filter into slot in hood and secure filters in place by tightening screw
located at front of filter. DO NOT OVERTIGHTEN.
2. Remove any protective plastic adhered to the range hood.
3. Turn switches to the OFF (
) position and restore power.
Test that the light and the fan are operating properly.
4. If there is any vibration noise, check for the source and try
to tighten fasteners or adjust the tape to make a tighter
connection or seal.
SECTION 7
Operation
Controls
Your Range Hood is equipped with two sliding switches with one
controlling the lighting and the other controlling the exhaust fan.
The light control has two positions, ON (
) and OFF ( ). The
fan is a four position control, HIGH (III), MEDIUM (II),LOW (I), and
OFF (
) (Figure 11).
SECTION 8
Maintenance
CAUTION: MAKE SURE POWER IS SWITCHED OFF AT
SERVICE PANEL BEFORE SERVICING THE UNIT.
Filters
Grease Filter - Included with your range hood are aluminum
grease filters that should be washed at least once a month.
4. To install the optional top section, mark the location of the
included horizontal mounting bracket using the bracket as a
template. Make sure the bracket is level and in line with the
bottom section. The height will be dependent on your installation
requirements. Make sure the slots in the side of the chimney
will match the holes in the mounting bracket. Drill holes into
wall using a 1/4" drill bit. Install included wall anchors into holes
and secure bracket into place with two provided 3.19 x 32 mm
screws (Figure 9).
5. Raise top chimney in place over horizontal mounting bracket
and secure in place with the two included 3.5 x 9.5 mm screws
(Figure 9).
SECTION 6
Finishing the Installation
1. Install the appropriate filters.
Charcoal Filters: If the range hood will be run ductless install
model BCCF-01 charcoal filters on both sides of the motor.
This is done by lining up the keyhole slots of the filter with the
mounting post on the motor and pressing the filter into place.
Turn filter slightly, so that it locks into place (Figure 10).
Figure 11
Figure 8
Details of duct collar, ducting, and electrical have
been omitted from drawing for clarity purposes.
Figure 9
Mounting
Bracket
Figure 10
Charcoal Filter
Grease Filter