Filter
Top Products
5
Installation
Reinstallation of the Doors
1. Install hinge assemblies:
• Install top hinge loosely with
5
⁄16” hex head
screws.
• Install center hinge with Phillips screws.
•
Freezer door models: Install bottom hinge with
3
⁄8” hex head screws.
2.
Freezer door models: Insert bottom
hinge pin.
• Locate bottom hinge hole closest to
outside edge of cabinet, and insert
bottom hinge pin. Replace any door
shims, if present.
3.
Freezer door models: Place hinge
side of freezer door on bottom hinge
pin and hold freezer door upright
while installing center hinge pin with
5
⁄16” hex head driver.
• Replace plastic sleeve.
• Replace any applicable door shims.
• Make sure the hinge pin is installed tightly.
4. Place hinge side of refrigerator
door on center hinge pin.
5. While holding refrigerator door
upright, tighten down top hinge
with
5
⁄16” hex head driver and
replace hinge cover.
Door Reversal
In some installations, reversing the door swing allows
for more convenient access to stored items. Both
doors can be reversed on freezer door models and the
fresh food door is reversible on freezer drawer models.
1. Remove door(s) (see page 4).
2. Transfer cabinet plugs and cabinet
screws to opposite side of cabinet.
• Remove cabinet plugs with flat
blade of screwdriver tip wrapped
in masking tape.
• Remove center mullion screws
with
5
⁄16” hex head screwdriver.
•
Freezer door models: Remove
bottom mullion screws with
3
⁄8” hex head driver.
2. While supporting door front,
hook supports into tabs
located on inside of rail.
To Install:
1. Pull both rails out to full
extension.
3. Lower door front into
final position.
4. Replace and tighten Phillips screws that were
removed from each side of rail system (select
models).
5. Place the basket cradles back onto the side rails.
Align snaps with the slots on the side rails and
press each snap towards the rail until it clicks.
6. With rails pulled out to full extension, set the
basket straight down into the basket cradles.
7. Slide upper basket into freezer. Make sure that rear
of basket hooks behind rail catch.
Basket cradle
snap attachments