Filter
Top Products
20
ICE DISPENSER
OPERATION
To dispense ice:
➢ Select CUBED or CRUSHED ice
mode by pushing button on dispenser
control panel. A green indicator light
above button shows mode selection.
➢ Press container
against dispenser
pad. When
dispensing crushed
ice, hold container as
close to chute as
possible to reduce spraying.
Selection mode may not be
changed while ice dispenser is in
operation.
NOTE: If dispenser is active for more
than 3 minutes, an automatic lock out
sensor will shut down power to
dispenser area. See Dispenser Lock for
unlocking information.
DISPENSER LOCK
(SELECT MODELS)
This feature prevents ice or water from
being dispensed.
To lock dispenser:
➢ Press and hold DISPENSER LOCK
button for 3 seconds. A green
indicator light above button confirms
dispenser is locked.
To unlock dispenser:
➢ Hold DISPENSER LOCK button for 3
seconds. Green indicator light above
button will go out.
FILTER STATUS
INDICATOR LIGHT
(SELECT MODELS)
The filter status indicator light
serves as a reminder to replace the
water filter. A green light indicates that
the filter is in good condition. A red light
indicates the filter should be changed.
Once light turns red, it will remain red
until function is reset.
To reset indicator:
➢ Press and hold both DISPENSER
LOCK and WATER buttons
simultaneously for 4 seconds. The
green filter status indicator light will
flash 3 times when the function has
successfully reset.
AUTO LIGHT
(SELECT MODELS)
The Auto Light function offers the ability
to activate the dispenser light at half-
power when the Light Sensor detects
that the light levels in room are low.
To activate Auto Light:
➢ Press AUTO LIGHT button located
on control panel. A green indicator
light above button displays to show
that sensor is active.
To deactivate Auto Light:
➢ Press AUTO LIGHT button. Green
indicator light will go out.
NOTE: Dispenser light will operate
whether or not Auto Light is selected.
SABBATH MODE
(SELECT MODELS)
This mode is intended to deactivate
power to the LED and dispenser lights,
while allowing the controls to remain
operational.
To activate Sabbath Mode:
➢ Press and hold both DISPENSER
LOCK and AUTO LIGHT buttons
simultaneously for 3 to 4 seconds.
After 3 to 4 seconds, the LED and
dispenser lights will turn off.
Dispenser light will not activate
during dispensing while in this
mode.
To deactivate Sabbath Mode:
➢ Press and hold both DISPENSER
LOCK and AUTO LIGHT buttons
simultaneously for 3 to 4 seconds.
After 3 to 4 seconds, the LED and
dispenser lights will activate.
NOTE: In the event that power is
interrupted while the Sabbath Mode is
active, the control will remain in Sabbath
Mode when power returns.
control features
NOTE: These directions pertain to 5-button and 3-button controls only. If your unit has LCD controls, please refer to the information
booklet located in your literature packet.
Dispenser features,
cont.