Amana ARS2661BB Refrigerator User Manual


 
6
Installing your refrigerator,
cont.
INSTALLING FRONT-
MOUNTED HANDLES FOR
STAINLESS STEEL
1. Loosen lower door clip
on door with
1
4" hex nut
driver.
2. Locate predrilled hole at
base of handle, and fit
hollow end of handle
over lower door clip.
3. Fit other end of
handle over upper
door clip and slide up as far
as possible.
NOTE: If top of handle
does not fit over top clip,
loosen lower clip further
until fit can be accomplished.
4. Insert
1
4" hex nut
driver into predrilled
hole at base of
handle to tighten
screw. Insert screw
plug into hole, as illustrated.
5. Repeat above steps to install other
handle.
INSTALLING STANDARD
HANDLES
1. Remove four
1
4" hex nut
screws from top and
bottom of doors.
2. Align door handles with
screw holes and insert
1
4"
hex nut screws removed in
step 1.
3. Snap handle trim over screw
holes at top and bottom of
handles.
Snap in trim by inserting
large round end first.
4. Repeat instructions 1-3 to install the
other handle.
REMOVING STANDARD
HANDLES
1. Remove handle trim from
handles with a very small
flat-blade screwdriver.
IMPORTANT: Wrap blade of
screwdriver with masking tape to
avoid damaging unit.
2. To release handles, remove
1
4
" hex nut screws from top
and bottom of handles.
3. Repeat instructions 1-2 to remove the
other handle.
REMOVING FRONT-
MOUNTED HANDLES FOR
STAINLESS STEEL
1. Remove screw plug at
base of handle with a
very small flat-blade
screwdriver.
Insert
1
4" hex nut driver
into predrilled hole to remove
screw.
2. Slide handle down and
remove from bottom door
clip.
3. Repeat above steps to
remove other handle.