Filter
Top Products
12
• Install the unit close to
the outside wall on
which the supply and
exhaust hoods will be
mounted.
• Have a nearby power
supply 120 Volts, 60Hz.
• Have the possibility of
mounting the unit to
supporting beams.
• Mount the unit as
level as possible in
order to allow proper
condensate drainage.
• Have access to
a water drain for the
condensate of the unit
during defrost.
• Have a certain amount
of heat around the unit
(attic installation is not
recommended).
• Minimize any noise
level that would be
created by the unit in
the living area.
• Have access for future
maintenance.
2 Install the drain hose,
making a “P” trap
INSTALLATION
PRACTICAL TIPS
3 Hang the unit by
slipping a link onto the
hanging hooks, making
sure the unit is level.
2 Attach a hanging chain
(provided) to each 10 3/4”
(19 mm) bolt (provided) in
the top 4 corners of the
unit and tighten.
1 Place Fastening hooks
on the strapping board
or the floor joists.
1 Install the drain nipple.
Installing Drain Line
Through normal operation and during its defrost mode, the HRV may produce some condensation.
This water should flow into a nearby drain, or be taken away by a condensate pump. The HRV and
all condensate lines must be installed in a space where the temperature is maintained above the
freezing point. A “P” trap should be made in the drain line. This will prevent odors from being
drawn back up into the unit.
MOUNTING
LOCATION
The HRV must be located in a heated space where it will be possible to conveniently service the
unit. Typically the HRV would be located in the mechanical room or an area close to the outside
wall where the weatherhoods will be mounted. If a basement area is not convenient or does not
exist, a utility or laundry room may be used.
Attic installations are not normally recommended due to:
- the complexity of work to install
- freezing conditions in the attic
- difficulty of access for service and cleaning
Connecting appliances to the HRV It is not recommended, including:
- clothes dryer
- range top
- stovetop fan
- central vacuum system
These appliance may cause lint, dust or grease to collect in the HRV , damaging the unit.
NOTE: Connecting any of these type of appliances to the HRV will invalidate your warranty