Filter
Top Products
15
Cleaning Interior, Exterior, and Door
WARNING
!
To avoid electrical shock which can cause severe
personal injury or death, unplug power cord or open
circuit breaker to oven before cleaning.
Clean microwave oven with mild detergent in warm water
using soft sponge or cloth. Wring sponge or cloth to
remove excess water before wiping equipment. If desired,
boil a cup of water in microwave oven to loosen soil
before cleaning.
Do not use abrasive cleansers or cleaners containing
ammonia. These could damage finish.
Never pour water into microwave oven bottom.
Do not use water pressure type cleaning systems.
Cleaning Air Intake Filter
CAUTION
!
To avoid overheating and oven damage, clean air filter
regularly.
Clean air intake filter weekly for proper air flow. Wash
filter in hot water and mild detergent. Do not use oven
without filter in place. Filter is located just below oven
door.
To remove, turn thumbscrews counterclockwise.
To reinstall, position filter over air intake and turn
thumbscrews clockwise.
Removing Air Intake Filter
Care and Cleaning
User Options
Follow the instructions below to customized the
microwave ovens operation. End-of-cycle signal,
maximum heating time and other options can be changed
to meeting your cooking needs.
1. Open oven door. Display shows door.
If door is closed or STOP/RESET pad is pressed
before finishing programming sequence, oven exits
programming mode.
2. Press and hold pad 1 for approximately 5 seconds.
After 5 seconds, signal sounds. Display shows P.
3. Press hidden enable pad.
Locate hidden enable pad to the immediate left and
slightly down from the MENU 1 pad. Display shows
"OP:1X". "OP" represents optional program
mode. First number represents option number and
second number represents functions currently
selected for option.
4. Press START pad to advance to other options.
See chart for function options.
5. Press STATUS pad to change option.
Press START to save changes.
6. Repeat steps 4-5 to change additional options.
7. Press hidden enable pad to return to programming
mode.
Press STOP/RESET pad or close oven door to exit
programming mode.
Option Description Code
End-of-cycle
signal tone
Off OP:10
Continuous
tone*
OP:11
5 continuous
tones
OP:12
5 tones, 5 cycles OP:13
Tone when pad
is pressed
Off OP:20
On* OP:21
Control panel
resets when
door is opened
Off* OP:30
On OP:31
End-of-cycle
signal
Loud* OP:40
Medium OP:41
User time limit Off OP:50
On* OP:51
Thumbscrews