Filter
Top Products
8
Interrupting Operation
• Open oven door or press
RESET
pad to interrupt
operation. Oven fan continues to operate. Display
continues to show countdown time. Close door and
press
START
pad to resume oven operation.
Canceling Mistakes
• If oven is not operating, press
RESET
pad to clear
display.
• If oven is operating, press
RESET
pad once to stop
oven, then again to clear display.
• If oven door is open and time shows in display, close
oven door and press
RESET
pad to clear display.
Microwave Utensils
Recommended Not Recommended
Glass/ceramic Aluminum foil
Natural fiber cloth Grocery bags
Non-recycled paper Recycled paper
Plastic Lead crystal,
Wood Newspapers
Metal,
Metallic trimmed china
Utensil Check Test
Use the following test to check utensils for microwave
safeness.
1. Place glass measuring cup of water next to
empty dish to be tested in microwave oven.
2. Heat for one minute.
3. Check temperature of dish and water.
• If dish remains cool and water is hot, dish is
microwave safe.
• If dish is slightly warm, use for short term cooking
only.
• If dish is hot and water is cool, do not use. Dish
remains cool if not absorbing microwaves and
microwaves are being absorbed by water. Dish
becomes hot if absorbing microwaves.
Operating Preprogrammed Pads
Equipment has 2 menus with 10 preprogrammed number
pads. Instructions are written for factory programmed
ovens. Ovens that are reprogrammed can respond
differently than described below.
1. Open oven door, place food in oven, and close oven
door.
• Display shows “b” or “d” and “READY”.
• Fan and light operate.
• If pad is not pressed in 30 seconds, open and
close oven door again.
2. Press
MENU
pad to select preprogrammed menu if
necessary.
• “b” or “d” shows in display.
3. Press desired number pad.
• Oven operates and time counts down.
• Display shows “POWER” only when microwave
energy is present.
• If power level less than 100 percent power was
programmed, display shows “COOK LEVEL” and
power level. Display counts down cooking time.
• If additional heating time is required, press
preprogrammed pads before or after heating cycle
ends.
4. Oven stops heating and oven signal sounds when
heating timing elapses.
Preprogrammed Times and Cook Level
All preprogrammed pads arrive set at full power.
Pads Heating Times
1 10 seconds
2 20 seconds
3 30 seconds
4 45 seconds
5 1 minute
6 1 minute 30 seconds
7 2 minutes
8 3 minutes
9 4 minutes
0 5 minutes
Operation