Amana rfs11MP Microwave Oven User Manual


 
9
Reviewing Preprogrammed Pads
1. Open oven door.
Display shows “b” or “d” and “READY”.
Fan and light operate.
If dooris closed or
RESET
pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold
TIME ENTRY
pad for approximately
15 seconds.
After 15 seconds, signal sounds. Display shows
“Pb” or “Pd” indicating “b” or “d” menu.
3. Press
MENU
pad to select preprogrammed menu if
necessary.
4. Press desired number pad.
Display shows heating time, pad number, and
power level if less than 100 percent power.
5. Press
TIME ENTRY
pad to review heating stages for
pad.
“(b or d)P” and stage show briefly, then heating
time, pad number and power level if less than 100
percent power show in display.
6. Press
START
pad after reviewing preprogrammed
pad.
Display shows “Pb” or “Pd” indicating “b” or “d”
menu.
Repeat steps 3-6 to review another preprogrammed
pad.
7. Press
RESET
pad or close oven door to exit
programming mode.
Manual Time Entry
1. Open oven door, place food in oven, and close door.
Display shows “b” or “d” and “READY”.
Fan and light operate.
If pad is not pressed in 30 seconds, open and
close oven door again.
2. Press
TIME ENTRY
pad.
Display shows “0000” and “READY”.
3. Press number pads to enter desired cooking time.
For example, to heat for 2 minutes 30 seconds,
press
2
,
3, and 0
pads.
4. Press a power level pad if power level less than 100
percent is required.
Display shows current power level if less than 100
percent power.
To restore power level to 100 percent, reenter
cooking time.
5. Press
START
pad.
Oven operates and time counts down.
Display shows “POWER” only when microwave
energy is present.
If power level less than 100 percent power was
programmed, display shows power level. Display
counts down cooking time.
6. Oven stops heating and oven signal sounds when
heating timing elapses.
Preprogrammed Number Pads
1. Open oven door.
Display shows “b” or “d” and “READY”.
Fan and light operate.
If dooris closed or
RESET
pad is pressed before
finishing programming sequence, oven exits
programming mode.
2. Press and hold pad
1
for approximately 15 seconds.
After 15 seconds, signal sounds. Display shows
“Pb” or “Pd” indicating “b” or “d” menu.
3. Press
MENU
pad to select preprogrammed menu if
necessary.
4. Press desired number pad.
Display shows heating time and power level if less
than 100 percent power.
5. Press number pads to enter desired cooking time.
For example, to heat for 2 minutes 30 seconds,
press
2
,
3, and 0
pads.
6. Press a power level pad if power level less than 100
percent is required.
Display shows current power level if less than 100
percent power.
To restore power level to 100 percent, reenter
cooking time.
7. Press
START
pad to save new heating time and
power level in oven memory.
Display shows “Pb” or “Pd” indicating “b” or “d”
menu.
Repeat step 3-8 to program additional pads.
8. Press
RESET
pad or close oven door to exit
programming mode.
Programming