Filter
Top Products
NA
13
! Use the appropriate protection to open the service
door when the brew unit is assembled.
1. Remove the
protection located in
the lower part of the
machine.
• Wash the two steel
filters of all coffee
residues.
• The brew group
must be cleaned only
with warm water and
no detergents. Wash
all parts and dry
thoroughly.
• Thoroughly clean the inside compartment of the
machine.
• Before inserting the
brew group, make sure
that all components are
correctly positioned;
hook in top position and
lever in bottom position.
2. Install the protection
in the brew unit pushing
it inward.
3. Open the service
door leaving the
protection in the brew
unit.
! In the protection there
is a sponge which
collects the coffee
residues. When the
operations have been
completed, wash the
sponge under running water.
! Once finished, remove the protection and restore the
brew unit correctly to its position.
The brew group must be cleaned every time the coffee
bean container is filled and at least once a week.
• Switch off the machine by pressing the main switch
to “O”.
• Remove the drip
tray and the dregs
drawer. Open the
service door.
• Remove the brew
group by the handle
and press the key
marked “PUSH”.
• Press the “PUSH”
button firmly to move
the lever back to its
initial position.
• Press the group in
the indicated point to
move the lever back to
its correct position.
• Take the handle and
return the brew group
to the compartment
clicking it into place.
Close the door.
• Place the dregs
drawer and the grill in the drip tray before inserting
into the machine.
! For perfect efficiency of the brew group, a
maintenance kit is available.
We recommend to use the maintenance kit every
12 months of use. For more information on where to
purchase the maintenance kit, please email to:
service@aristonamerica.com or call 1-877-356-0766.