Filter
Top Products
3-. Safety
Important Safeguards
1-. Read all instructions
2-. Do not touch hot surfaces. Use
handles or knobs.
3-. To protect againts fire, electric shock
and injury to persons do not immerse
cord, plugs or (state specific part or
parts in question) in water or other
liquid.
4-. Close supervision is necessary when
any appliance is used by or near
children.
5-. Unplug from outlet when not in use
and before cleaning. Allow to cool
before putting on or taking off parts
and before cleaning the appliance.
6-. Do not operate any appliance with
a damaged cord or plug or after the
appliance malfunctions, or has been
damaged in any way. Return
appliance to the nearest authorized
service facility for examination, repair
or adjustment.
7-. The use of accesory attachments
not recommended by the appliance
manufacturer may result in fire,
electric shock or injury to persons.
8-. Do not use outdoors (this item may
be omitted if the products is
specifically designed for outdoor
use).
9-. Do not let cord hang over edge of
table or counter or touch hot
surfaces.
10-.Do not place on or near a hot gas
or electric burner or in a heated
oven.
11-.Always attach plug to appliance
first, then plug cord into the wall
outlet. To disconnect, turn any
control to off then remove plug
from wall outlet.
12-.Do not use appliance for other than
intended use.
13-.Save these instructions.
Before setting the appliance going, the
person installing should read this manual
carefully. The operator should be a
responsible adult.
In the event of any anomaly, contact
your distributor.
Start-up
1-.Check the electrical voltage is the
same as the voltage displayed on
the machine specifications label.
2-.Fill the reservoir with fresh water. (see
picture 1) Check the water intake
tube is immersed in the reservoir.
The use of low mineral water is
recommended. Water quality affects
the taste and quality of the coffee, in
addition to preventing future
breakdowns. Consult us about our
filters (descaling treatment)-optional.
3-.Plug it into the mains.
Important:
MOBILE FILTER HOLDER SYSTEM
A) The machine is being used for the
first time or has not been used for
some time.
Change the water in the boiler and
circuit.
1-.Connect the coffee machine with
switch 0/1
1
.
2.-
Put the filter holder
7
without coffee
into position and a recipient below.
3-.
Switch on the coffee switch
2
and
run approximately half a reservoir
capacity of water through it.
Careful: Check that the reservoir has
enough water. If the coffee
machine is used without water,
pump resistance may be damaged.
B) PRIMING.
l
If coffee does not emerge, when the
machine has not been used for some
time
l
After producing steam
l
If there is no water in the reservoir,
the following procedure should be
performed:
1-.
Turn on the steam tap
4
with the
coffee machine switched on.
2-.
Turn on the coffee function
2
and
allow the water to come out (one cup)
through the steam tube
5
.
3-.
Turn off the coffee function
2
and
turn off the steam tap
4
.
The coffee machine is now ready for
use.
C)After steam has been produced, it
is very important to wait for the pilot light
6
to go on again and either to switch
off or to perform priming.
FIXED FILTER HOLDER SYSTEM
Step A is unnecessary. Step B and C
are necessaries.
4-. Preparation of coffee
Please, check your system:
(ground , versatile, pod)
Ground
(Only ground system)
Any type of coffee may be used. For
optimum results, we recommend using
special "espresso" coffee blends as they
provide a suitable grind. If the coffee
comes out either very quickly or very
slowly, the type of coffee should be
changed for another finer or thicker grind
and tamping of the coffee should be
varied according to our
recommendations.
1-.Switch on the machine using the main
switch 0/1
1
and place the filterholder
(with the filter) into the group.
2-.
Wait for the pilot light
6
to switch off
(approx. 1.5 minutes). This means
the coffee machine has reached the
ideal temperature. Press coffee switch
2
and let water run out. Do this
before making the coffee. This will
remove residue and balance the
temperature to create optimum
working conditions.
3-.Fill the coffee filter basket (1 or two
coffees according to requirements),
Three-quarter size. The filter must be
filled to 3/4 of its capacity, once
pressed.(see picture 2A)
4.-Clean off the remains of coffee that
have been deposited on the edges
of the filter basket so that it fits
perfectly.
5-.
Place the filter holder
7
into the group
8
starting from the left and turning
towards the right with enough
pressure at the end. (see picture 3)
6-.Put the cups or cup on the grille and
switch on the coffee switch
2
.
7-.When the coffee has finished being
made, switch off the coffee switch
2
. It takes 20/25 seconds to make
an espresso perfectly
ascaso ascaso
ENGLISH
ENGLISH
18 19
Picture 2B
!
Picture 2A
Pictute 1
DREAM
ARC
BASIC
ELIPSE
Picture 1