Filter
Top Products
12
The temperature set is shown on the electronic programmer display and can be varied,
with 5 °F (5 °C) intervals, by means of the programmer keys.
During the cooking the oven temperature (°F or °C) is measured by a sensor inside the
cavity and is shown on the programmer display until setted temperature is reached. If
setted temperature is less than inside oven temperature, the display shows the setted
temperature.
1.
SELECTING THE COOKING FUNCTION
Turn the selector knob to the cooking function required
The pre-set temperature appears on the programmer display. °
F or °C flashes on the
display for 3 seconds. The heating elements start cooking immediately.
2.
SETTING THE COOKING TEMPERATURE
The temperature can be changed when °F or °C is flashing on the display
2a. If °
F or °C is not flashing press key 4 of the programmer.
2b.Press key 6 to increase the temperature or key 5 to reduce it.
The maximum temperature which can be set is 480 °F (250 °C) while the minimum
temperature is 120 °F (50 °C).
Note: When °
F or °C becomes steady the value shown on the display indicates the oven
cavity temperature until setted temperature is reached. If setted temperature is less than
inside oven temperature, the display shows the setted temperature.
Caution: If a temperature below the minimum value (120 °F or 50 °C) is set the system
switches off automatically and
OFF appears.
In this case repeat the procedure from point 2.
3.
SWITCHING OFF
Turn the selector knob to position OFF (oven OFF). The programmer display shows
the time.
I
I
I
I
I
I
I
I
I
I
I
I
I
4
56
SETTING THE COOKING (ONLY FOR THE COOKING FUNCTIONS)
SELECTING °F/°C ON THE DISPLAY
Function selector knob
Programmer
➀
➀
➁
2a 2b
1. Turn the oven selector knob to a cooking function (i.e. convection cooking).
2. Press key 5 on the programmer to reduce a temperature until you reach the mini-
mum value (120 °F/50 °C). If °F/°C is not flashing on the display press key 4 of the
programmer before pressing key 5.
3. With °F/°C flashing on the display press key 5 again (if °F/°C is not flashing press key
4 before pressing key 5) until OFF appears on the display.
4. Keep key 4 pressed for about 3/5 seconds until the display changes from °C to °F or
vice versa. During selection °C or °F is flashing.
5. When OFF apears again on the display turn the selector knob to OFF position; the
selection to °C or °F has been completed.
5
4
I
I
I
I
I
I
I
I
I
I
I
I
I
5
➂
4
➃
➄
ቤ
➁