Filter
Top Products
10
Operating Your Dishwasher
a) Ensure that all Electrical, Water, and Drain connections have been installed correctly before
proceeding.
b) Load the dishwasher accordingly (See the “Loading the Dishwasher Rack” section on pages 15 –
16).
c) Add the appropriate amount of dishwasher detergent to the dispenser (See the section “Proper
Use of Detergent” on page 13).
d) Close the door and ensure that the door latch has engaged.
e) Turn the dishwasher ON by pressing the ON / OFF button.
f) Select the appropriate wash cycle / program (See the Cycle Sequence / Program Description
section on page 12).
g) Make sure that the water supply is turned on to full pressure.
h) Press the Start/Reset button, the dishwasher will begin to start. The START / RESET indicator
light will begin to flash intermittently to indicate the dishwasher is in “RUN” mode.
NOTE:
When you press the Start/Reset button to pause during washing, the program light will stop blinking and
the dishwasher will beep once every minute unless you press the Start/Reset button to start (See Pausing
the Wash Program / Cycle).
Pausing the Wash Cycle / Program:
In order to make any changes to the selected wash program / cycle, load additional items, or remove
previously loaded items the dishwasher must be put in a “PAUSED” status. The dishwasher can be put
into PAUSE mode at any time during the wash cycle.
To temporarily pause the washing process follow these steps:
a) Press and hold the START / RESET button for approximately 3 seconds.
(The START / RESET indicator light with be ON indicating that the unit is in PAUSE mode. While
in the PAUSE mode you will hear a beep once every minute until the dishwasher is put back into
normal operation or “RUN” mode.)
b) Make the necessary changes to the wash program / cycle selection, add/remove the items from
the dishwasher.
c) Ensure that the door is closed and the latch is fully engaged.
d) Press the START / REST button once
e) The dishwasher will immediately resume operation using the selected wash program / cycle.
NOTE:
If the door is opened at any time during the washing process, the dishwasher will automatically go to the
PAUSE mode. Once the door is closed and the latch is fully engaged the dishwasher will immediately
resume operation as normal. Although the dishwasher will be put in the PAUSE mode by opening the
door, it is recommended that you follow the steps above to PAUSE the washing process.